diff --git a/README.largedisk b/README.largedisk deleted file mode 100644 index 854dd3d..0000000 --- a/README.largedisk +++ /dev/null @@ -1,12 +0,0 @@ -Some hints on fdisk and large disks (> 2TB) -------------------------------------------- - -Note that fdisk only supports legacy partition tables. -Legacy partition tables (like DOS) use 32 bit LBA addressing, -which means that you can only address partitions with a starting -sector and a size with a maximum of 2**32 sectors = 2TB. -This means you can not create partitions that are greater than 2TB -with fdisk! -If you want to use partition sizes above this limit, you need to use -GUID Partition Tables (GPT) which use 64 bit LBA addressing. -They are supported by parted. diff --git a/README.raw b/README.raw deleted file mode 100644 index 6696ec8..0000000 --- a/README.raw +++ /dev/null @@ -1,54 +0,0 @@ -Raw device driver support on SLS 9 - -On SLS 9, you will notice that by default, raw devices (nodes) (/dev/rawctl -and /dev/raw/rawN (1-15)) no longer exist whereas in SLES 8, the raw nodes were -created when the system was initially installed. SLS 9, by default, uses -the new dynamic userspace implementation "sysfs" together with "udev" which -replaces the previous static "dev" system. - -Raw devices are moving towards eventual obsolescence with block+O_DIRECT -support intended as a replacement. The primary application users of raw -character devices have been databases so the database you are using will have -to support the O_DIRECT functionality before moving away from raw character -devices. - -Using RAW with kernel 2.6 (SLS 9) ---------------------------------- -Raw device usage in kernel 2.6 together with udev and sysfs was intended to be -quite seamless. Basically, all that is required is to load the raw module after -each reboot using the commands "modprobe raw" or "rcraw start". Then use the -"raw" command to create the bindings to the block character devices. The raw -device nodes are no longer required to exist before the bindings are assigned -and used. - -Using a single script, you can you load the raw module and bind the raw nodes -to block devices. - -#!/usr/bin -# load the raw module -modprobe raw # can also use "rcraw start" -# create the raw bindings -raw /dev/raw/raw1 /dev/sdb1 -raw /dev/raw/raw2 /dev/sbc1 - -You can see if the raw driver is available by issuing "rcraw status". If the -raw driver is loaded, the command should return a status of "running". A status -of "dead" will usually indicate that the driver was not loaded or -the /dev/rawctl file does not exist. The /dev/rawctl file is automatically -created when the module is loaded. This file and the /dev/raw/rawN nodes can -also be viewed under the /sys/class/raw directory. - -Raw node permissions ----------------------------------- -When the raw devices are assigned, permission settings are determined from the -/etc/udev/udev.permission file. This file can be modified to assign different -owner, group and/or access permissions to the raw nodes. For example, by -default, the permission settings for raw nodes are as follows: - -raw/raw*:root:disk:660 - -Here, root:disk is the default owner:group with read write access for owner and -group. As an example, to create the raw nodes with an owner:group of -user1:group1 and read write access for all, change the assignment as follows: - -raw/raw*:user1:group1:666 diff --git a/nologin.8 b/nologin.8 deleted file mode 100644 index 1aceb4a..0000000 --- a/nologin.8 +++ /dev/null @@ -1,63 +0,0 @@ -.\" $OpenBSD: nologin.8,v 1.8 1999/06/04 02:45:19 aaron Exp $ -.\" $NetBSD: nologin.8,v 1.3 1995/03/18 14:59:09 cgd Exp $ -.\" -.\" Copyright (c) 1993 -.\" The Regents of the University of California. All rights reserved. -.\" -.\" Redistribution and use in source and binary forms, with or without -.\" modification, are permitted provided that the following conditions -.\" are met: -.\" 1. Redistributions of source code must retain the above copyright -.\" notice, this list of conditions and the following disclaimer. -.\" 2. Redistributions in binary form must reproduce the above copyright -.\" notice, this list of conditions and the following disclaimer in the -.\" documentation and/or other materials provided with the distribution. -.\" 3. All advertising materials mentioning features or use of this software -.\" must display the following acknowledgement: -.\" This product includes software developed by the University of -.\" California, Berkeley and its contributors. -.\" 4. Neither the name of the University nor the names of its contributors -.\" may be used to endorse or promote products derived from this software -.\" without specific prior written permission. -.\" -.\" THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND -.\" ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE -.\" IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE -.\" ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE -.\" FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL -.\" DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS -.\" OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) -.\" HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT -.\" LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY -.\" OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF -.\" SUCH DAMAGE. -.\" -.\" @(#)nologin.8 8.1 (Berkeley) 6/19/93 -.\" -.Dd February 15, 1997 -.Dt NOLOGIN 8 -.Os -.Sh NAME -.Nm nologin -.Nd politely refuse a login -.Sh SYNOPSIS -.Nm nologin -.Sh DESCRIPTION -.Nm -displays a message that an account is not available and -exits non-zero. -It is intended as a replacement shell field for accounts that -have been disabled. -.Pp -If the file -.Pa /etc/nologin.txt -exists, -.Nm -displays its contents to the user instead of the default message. -.Sh SEE ALSO -.Xr login 1 -.Sh HISTORY -The -.Nm -command appeared in -.Bx 4.4 . diff --git a/nologin.c b/nologin.c deleted file mode 100644 index fc0ff26..0000000 --- a/nologin.c +++ /dev/null @@ -1,58 +0,0 @@ -/* $OpenBSD: nologin.c,v 1.2 1997/04/04 16:51:37 millert Exp $ */ - -/* - * Copyright (c) 1997, Jason Downs. All rights reserved. - * - * Redistribution and use in source and binary forms, with or without - * modification, are permitted provided that the following conditions - * are met: - * 1. Redistributions of source code must retain the above copyright - * notice, this list of conditions and the following disclaimer. - * 2. Redistributions in binary form must reproduce the above copyright - * notice, this list of conditions and the following disclaimer in the - * documentation and/or other materials provided with the distribution. - * - * THIS SOFTWARE IS PROVIDED BY THE AUTHOR(S) ``AS IS'' AND ANY EXPRESS - * OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED - * WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE - * DISCLAIMED. IN NO EVENT SHALL THE AUTHOR(S) BE LIABLE FOR ANY DIRECT, - * INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES - * (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR - * SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER - * CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT - * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY - * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF - * SUCH DAMAGE. - */ - -#include -#include -#include -#include -#include - -/* Distinctly different from _PATH_NOLOGIN. */ -#define _PATH_NOLOGIN_TXT "/etc/nologin.txt" - -#define DEFAULT_MESG "This account is currently not available.\n" - -/*ARGSUSED*/ -int main(argc, argv) - int argc; - char *argv[]; -{ - int nfd, nrd; - char nbuf[128]; - - nfd = open(_PATH_NOLOGIN_TXT, O_RDONLY); - if (nfd < 0) { - write(STDOUT_FILENO, DEFAULT_MESG, strlen(DEFAULT_MESG)); - exit (1); - } - - while ((nrd = read(nfd, nbuf, sizeof(nbuf))) > 0) - write(STDOUT_FILENO, nbuf, nrd); - close (nfd); - - exit (1); -} diff --git a/util-linux.changes b/util-linux.changes index 53a1411..cd771a6 100644 --- a/util-linux.changes +++ b/util-linux.changes @@ -1,3 +1,11 @@ +------------------------------------------------------------------- +Tue May 27 21:17:40 UTC 2014 - sweet_f_a@gmx.de + +- use nologin from upstream (was added in 2.24) +- remove unknown configure options +- remove unused and outdated suse READMEs +- require bc for checks + ------------------------------------------------------------------- Fri May 16 15:10:53 UTC 2014 - sweet_f_a@gmx.de diff --git a/util-linux.spec b/util-linux.spec index 2373d3a..42dc9a1 100644 --- a/util-linux.spec +++ b/util-linux.spec @@ -23,6 +23,7 @@ Name: util-linux BuildRequires: audit-devel +BuildRequires: bc BuildRequires: binutils-devel BuildRequires: fdupes BuildRequires: gettext-devel @@ -67,9 +68,6 @@ License: GPL-2.0+ Group: System/Base Source: ftp://ftp.kernel.org/pub/linux/utils/util-linux/v2.24/%{name}-%{version}.tar.xz Source1: util-linux-rpmlintrc -# XXX: make nologin part of util-linux upstream -Source2: nologin.c -Source3: nologin.8 Source4: raw.init Source5: etc.raw Source6: etc_filesystems @@ -90,8 +88,6 @@ Source28: mkzimage_cmdline.8 Source29: mkzimage_cmdline.c Source31: addnote.c # -Source26: README.raw -Source30: README.largedisk Source50: uuidd.rc Source51: blkid.conf ## @@ -269,8 +265,6 @@ xzcat %{S:0} | %gpg_verify %{S:12} - # # setctsid cp -p %{S:22} %{S:23} . -# nologin -cp -p %{S:2} %{S:3} %{S:26} %{S:30} . pushd ../klogconsole %patch55 -p1 @@ -318,8 +312,6 @@ export SUID_LDFLAGS="-pie" --enable-raw \ --enable-write \ --enable-line \ - --enable-new-mount \ - --enable-login-utils \ --enable-tunelp \ --enable-socket-activation \ %if %{with enable_last} @@ -327,7 +319,6 @@ export SUID_LDFLAGS="-pie" %else --disable-last \ %endif - --enable-logger \ %if %{with enable_eject} --enable-eject \ %else @@ -355,7 +346,6 @@ export SUID_LDFLAGS="-pie" # make %{?_smp_mflags} # -%{__cc} -fwhole-program %{optflags} -o nologin nologin.c %{__cc} -fwhole-program %{optflags} -o mkzimage_cmdline %{S:29} %{__cc} -fwhole-program %{optflags} -o chrp-addnote %{SOURCE31} @@ -388,6 +378,7 @@ popd # util-linux install # %make_install +rm -f %{buildroot}/%{_libdir}/lib*.la #UsrMerge %if %{with enable_su} ln -s %{_bindir}/kill %{buildroot}/bin @@ -414,6 +405,7 @@ ln -s %{_sbindir}/mkfs.bfs %{buildroot}/sbin ln -s %{_sbindir}/mkfs.minix %{buildroot}/sbin ln -s %{_sbindir}/mkfs.cramfs %{buildroot}/sbin ln -s %{_sbindir}/mkswap %{buildroot}/sbin +ln -s %{_sbindir}/nologin %{buildroot}/sbin ln -s %{_sbindir}/pivot_root %{buildroot}/sbin ln -s %{_sbindir}/raw %{buildroot}/sbin ln -s %{_sbindir}/sfdisk %{buildroot}/sbin @@ -430,19 +422,11 @@ ln -s %{_sbindir}/fstrim %{buildroot}/sbin ln -s %{_sbindir}/chcpu %{buildroot}/sbin #EndUsrMerge install -m 644 %{SOURCE6} %{buildroot}%{_sysconfdir}/filesystems -install -m 755 nologin %{buildroot}/%{_sbindir} -#UsrMerge -ln -s %{_sbindir}/nologin %{buildroot}/sbin -#EndUsrMerge -rm -f %{buildroot}/%{_libdir}/libblkid.la -rm -f %{buildroot}/%{_libdir}/libuuid.la -rm -f %{buildroot}/%{_libdir}/libmount.la %ifnarch ppc ppc64 install -m 755 mkzimage_cmdline %{buildroot}/%{_bindir} install -m 644 %{S:28} %{buildroot}%{_mandir}/man8 install -m 755 chrp-addnote %{buildroot}/%{_bindir} %endif -install -m 644 nologin.8 %{buildroot}%{_mandir}/man8 # setctsid install install -m 755 setctsid %{buildroot}/%{_sbindir} install -m 444 setctsid.8 %{buildroot}%{_mandir}/man8/